Set the wall trimmer to the thickness of the carpet.
Laying wall to wall carpet.
The tacks on the strips are sharp and could poke through the carpet and hurt your feet.
The tacks on the strips are sharp and could poke through the carpet and hurt your feet.
The cost to install carpet depends on three factors.
Installing your own wall to wall carpet may sound daunting but with the right tools and some perseverance you can certainly install carpet yourself.
Clean and prep the floor.
8 apply latex seam sealer to carpet edges let dry.
6 cut carpeting to fit around wall corners.
Laying carpet with carpet pad.
Cut lengths of tackless strip to fit each wall around the perimeter of the room.
It s nailed to the subfloor with its points angled toward the wall.
This type of installation requires no glue or adhesive to hold the carpet and pad to the floor.
The carpet padding and the labor.
Installing carpet can be hard on your knees and back and you should be prepared to take some time to get the job done.
Cut the tackless strips to size with a strip cutter or heavy snips.
5 roll carpeting across the room.
After the carpet is attached along the first wall trim the excess from the edge using a wall carpet trimmer.
Nail the strips 1 2 from the wall.
Keep the tool s shoe pressed tightly against the carpeting and keep the carpet tight against the baseboard as you guide it along the wall.
Cut the tackless strips to size with a strip cutter or heavy snips image 1.
9 align the seams between carpeting pieces then slip piece of seam tape underneath.
7 when seaming two pieces of carpeting use a cushion back cutter to trim the carpeting edges.
Don t install tackless strips across thresholds or doorways.
Secure them with the pre driven nails into the subfloor keeping the strip out from the wall about 2 3 the thickness of the carpet.
Don t install tackless strips across thresholds or doorways.
Nail the strips 1 2 from the wall image 2.
At the home depot the cost of carpet installation is free on purchases of 699 or more.